Industrial Bearings Solutions Four row tapered roller bearings are used successfully worldwide for rolling mill bearing arrangements where rolling speeds are slow to moderate. Because of Bearing 89111D/89150/89151XD design they are able to take up those axial loads which occur in such applications in addition to radial loads and generally no separate Bearing 89111D/89150/89151XD are required in such arrangements. This means that the roll necks can be relatively short and the chocks at both sides of the roll can have the same design.
Four row tapered roller bearings, because of their design, must be installed as complete bearings in the chocks. To enable quick roll changes to be made Four row tapered roller bearings must therefore have a loose fit on the roll necks. Loose fits have the disadvantage that the inner rings wander on their seats under the prevailing load conditions causing wear to the seats which normally have a lower hardness than the rings. To alleviate the effects of a loose fit to some extent, i.e. to reduce wear, Industrial Bearings Solutions have a helical groove in the bore and/or lubrication grooves in the side faces of the inner rings. These grooves enable lubricant to be supplied to the contact surfaces of the inner ring and seat. Additionally, the grease-filled grooves can absorb the wear particles.An agreed response time, a performance-based model, a fixed price – what do you need for Bearing 89111D/89150/89151XD? Please contact Industrial Bearings Solutions.